Maintenance Lubricants - Sawcraft UK Limited

0121 561 5616

Gear Oil 220

Gear Oil 220

Gear Oil 220 is a high performance extreme pressure lubricant designed for industrial applications.

Not suitable for automotive use.

High load bearing capabilities which reduce gear tooth and bearing wear providing effective protection for both steel and bronze components.

Available in 5L, 25L, 215L, IBC 

Read More

Slideway Oil 68

Slideway Oil 68

Slideway 68 is a sophisticated machine tool lubricant designed to provide regular oil film pressure distribution. Enabling smooth relative linear movements between the sliding surfaces.

Specially formulated to prevent any sticky deposits on the slideways caused high unit loads and slow travel speeds.

Available in 5L, 25L, 215L, IBC

Read More

Hydraulic Oil 46

Hydraulic Oil 46

Hydraulic Oil 46 is a high performance hydraulic oil based on very highly refined mineral oil and offers outstanding antiwear, corrosion protection and antioxidant characteristics. In addition the products exhibits superior air release and demulsification as well as good filtration properties even when extremely fine filters are used.

Hydraulic oil 46 is a high viscosity index product and will therefore give effective performance in high temperature environments.

Available in 25L, 215L, IBC

Read More

Hydraulic Oil 32

Hydraulic Oil 32

Hydraulic Oil 32 is a high performance oil based on very highly refined mineral oil. The product exhibits superior air release and demulsification as well as good filtration properties even when extremely fine filters are used.

Hydraulic Oil 32 is a high viscosity index product and will therefore give effective performance in high temperature environments.

Available in 25L, 215L, IBC

 

Read More

Dewatering Oil

Dewatering Oil

Corrosion preventative oil that combines protective properties with outstanding water displacing qualities. Can be applied to both wet and dry parts.

Available in 25L, 215L, IBC

Read More

Application Advice

Application Advice

The key to successful application of our (and other) cutting fluids, is to direct as much coolant as possible in a continuous stream as closely as possible to the cutting edge.

This achieves the three primary aims; to lubricate the chip-blade interface, to transfer heat from the blade, and to remove the chip as cleanly and as quickly as possible.

View application advice